Knowledgebase
F5 Big IP Print this Article
After you obtain the certificate, you must copy it onto each BIG-IP Controller. You can configure certificates using the Configuration utility or from the command line.
Installation with Configuration utility
- click proxy in the navigation panel,
- window proxy will appear,
- click Install SSL Certificate Request tab,
- in the Certfile Name box type the name of domain with .crt extension,
- enter the certificate in the SSL Certificate section, do not forget the lines BEGIN CERTIFICATE and END CERTIFICATE,
- click Write Certificate File button to install certificate.
Installation with Command line
Copy the SSL to following directory on each BIG-IP Controller:
/config/bigconfig/ssl.crt/
If you used the genkey or gencert utilities to generate the CSR, a copy of the key should already be in:
/config/bigconfig/ssl.key/
Installation Intermediate CA with command line
Copy the intermediate CA certificate into each BIG-IP Controller. Open Intermediate certificate. Create a new file with it as intermediate-ca.crt (include also lines BEGIN and EN CERTIFICATE). Save file in /config/bigconfig/ssl.crt/
Note:
Certificates are stored in ssl.crt directory.
Before you configure the SSL Accelerator you must moved manually keys and certificates on both BIG-IP Controllers.
Was this answer helpful?
Related Articles
SSL installation depends on the type of server you are securing. Please select below the server...
Installing SSL certificate on Apache with mod_ssl To install certificate you need 2...
Log in to admin server as a root. Create a folder /etc/httpd/ssl.crt/ (if it does not exist)....
Installing SSL certificate on Barracuda VPN serverImport CertificatesFrom the appliance web...
Note: If the domain/site certificate is created using CA certificate, you need to repeat steps...